P.O. Box 1305, West Caldwell, NJ 07007-1305
PARTS OF THE TC-851
No. Name of Part Function
1 Sliding Feed Table A table on the machine for mounting the fixture and put on
the printing subject, slides manually to facilitate the printing process.
2 Handle For sliding the sliding feed table.
3 Fastening Screw Adjusts the sliding feed table to your requirement.
4 Balancing Plate For balancing and leveling the type/engraving holder to the
required level and achieve the best performance.
5 Pivot Screw Serve as a pivot for the balancing plate (4) which is leveled by
adjusting four leveling screws (9) on fixed plate (7).
6 Heating Block Holds the heater inside to generate heat required fot hot foil
printing and embossing.
7 Fixed Plate Attaching the balancing plate, heating block and type/engraving
holder to the sliding block.
8 Fixing Screws Tightens or loosens the type/engraving holder.
9 Leveling Screws Used to balance and adjust the level of the balancing plate (4).
10 Left Foil Guide Bar Guides the foil to the desired level.
11 Foil Holder Holds the roll of foil.
12 Fixing Ring Adjusts the position of the foil holder
13 Fuse
14 Grease Nozzle Greases the rotating shaft of he operating handle.
15 Foil Feed Timer Sets the length of foil feed.
16 Main Switch Power on/off switch.
17 Power Indicating Lighted when power is “on”.
18 Thermo Controller Adjusts temperature of the heating block (6) to suit printing
requirements.
19 Reset Button Resets the counter to zero.
20 Counter Indicates the number of runs achieved.
21 Hand Wheel Adjusts the shut height between type/engraving holder (33) and
sliding feed table (1).
22 Operating Handle When pulled down, applies pressure to the type/engraving and
the printing subject to accomplish the printing process,
23 Adjusting Nut Adjusts stroke of the type/engraving holder
24 Fixing Nut Fixes position of the adjusting nut (23) after the stroke has been adjusted.
25 Handle Holder Holding the operating handle (22).
26 Fixing Screw Fixes the operating handle (22) to the handle holder (25).
27 Used Foil Collector Collects the used foil.
28 Transmission Roller Transmits the rolling movement of nylon roller (31) to the used foil
collector (27).
29 Metal Roller Works in conjunction with nylon roller (31) to facilitate foil feeding.
30 Foil Feed Knob Advances foil manually and adjusts tension of foil.
31 Nylon Roller Provides constant transmission for foil feeding.
32 Right Foil Guide Bar Guides the foiil to the desired level.
33 Type Holder or Holds the type setting, or holds the stamping plates
Engraver Holder