Veneer Cutting Jig
I use a lot of wood veneers in my segmenting. Initially I was cutting the veneers with a utility
knife and ruler. I decieded I needed something more accurate and efficient. When I think
accurate and efficient, I often think of my table saw.
The following pictures show what I came up with. The jig has a runner which fits in the miter
slot. A couple of points when building the jig:
Assemble the base, leading and trailing edges first. When attaching the leading and trailing
edges don't use any metal attachments (brad nails or screws) in the area where the blade cut
will be.
Attach the runner. Make sure the runner fits snugly in the miter slot with no play.
Raise the blade 1". I used 3/4" MDF so this meant the blade would be 1/4" higher than the bed
of the jig.
Run the bed through the saw. You now have a cut line in the bed of the base which is perfectly
parallel to the miter slot without any measuring
Add the jig fence and hold down block with a handle. Make sure the screws attaching the
handle of the hold down jig are well offset to the cut line! The bed of my jig will accept a piece of
veneer just over 12" long. I made the fence so that I could rip/crosscut a piece of veneer up to
2"
A good coat of wax on the base of the jig and runner will help it to glide smoothly.
Because the cut in the base is now a zero clearance kerf and you are supporting the top of the
workpiece with the hold down block, I'm able to cut the veneer with no tear out at all.
You can click on any of the images to see a larger version.
