Ardex TPO Roofing Membrane | Product Certificate

Product Use and Scope

Ardex TPO Roofing Membrane are waterproofing

membranes for roofs constructed to drain water to

gutters and drain outlets

 on buildings

o complying with the structural requirements of

the NZ Building Code, and

o in all wind zones up to and including extra high

for buildings designed to NZS3604:2011 or up

to 3.0 kPa ULS pressure differential for

buildings specifically designed

 where the membrane is applied to a plywood or

suspended concrete substrate

Certificate Holder

Ardex New Zealand Limited

32 Lane Street

Woolston

Christchurch

Ph: 03 3736909

Website: http://www.ardex.co.nz/

CodeMark Certification

Body

AsureQuality, 11 Hull Road,

Mt Maunganui

New Zealand

Tel. 0508 00 11 22

www.asurequality.com

This is to Certify

Ardex TPO Roofing Membrane

Product Description

Ardex TPO Roofing Membrane is a single ply; adhesive fixed, polyester weft reinforced thermoplastic

polyolefin waterproofing sheet membrane.

Ancillary Components:

Ardex WPM 623 – TPO Flashing Ardex TPO Inside/Outside Corners

Ardex TPO Universal and Large Pipe Flashing Ardex TPO QuickSeam Flashing

Ardex WPM 642 – Water Based Bonding Adhesive Ardex WPM 651 – TPO Cut Edge Sealant

Ardex WPM 657 – TPO General Purpose Sealant Ardex WPM 659 – TPO Pourable Sealant

Ardex All Purpose Fasteners Ardex HD Seam Plate

Ardex Pressure Seal

Complies with the Building Code of New Zealand:

If installed and maintained in accordance with the conditions of this certificate, the Ardex TPO Roofing Membrane will

comply with;

B2 Durability - B2.3.1 (b)

E2 External Moisture - E2.3.2

F2 Hazardous Building Materials - F2.3.1

If installed and maintained in accordance with the conditions of this certificate, the Ardex TPO Roofing Membrane will

contribute to compliance with;

E2 External Moisture - E2.3.1

Subject to the following conditions and limitations:

Conditions

1. Ardex TPO Roofing Membrane must be designed and installed in accordance with the Ardex Waterproofing Systems Manual (March2013)

2. Ardex TPO Roofing membrane must be installed by Ardex New Zealand Limited approved applicators

3. The substrate structure must be designed to comply with E2.3.1 i.e. designed to shed precipitated moisture. The following details contribute to

those requirements without specific design:

a. the roof is constructed to a fall no less than 2 degrees (1:30), and

b. has no integral roof gardens

4. Allowance for deflection and settlement of the substrate must be made in the design to ensure falls are maintained and no ponding of water can

occur.

5. Ardex New Zealand Ltd will notify AsureQuality Ltd in accordance with Regulation 15 of the Building (Product Certification) Regulations 2008

Limitations

1. The design and construction of the substrate and movement and control joints is specific to each building and is outside the scope of this

certificate

2. The weather tightness design of all junctions on specifically designed buildings is outside the scope of this certificate.

Date of Issue

May 2016

Certificate Number AQ-040516-CMNZ